AIR CONDITIONING INSTALLATION

Service Description
Charge from installer to customer

Cleaning of refrigerant pipes with nitrogen, per installation, in cases of:

Where there are open pipes.
Moisture in the circuit: €10.00
Removal of air conditioner (9000-24000 BTU): €20.00
Use of additional copper pipes (per meter):
For air conditioners 9K to 14K BTU: €18.00
For air conditioners 16K to 24K BTU: €20.00

Adding refrigerant gas in cases where the distance from the outdoor unit to the indoor unit exceeds the manufacturer’s recommended distance (per kilogram): Base charge: €15.00

€50.00/kg

Use of additional water drainage pipe (per meter): €3.00
Use of additional power supply cable cover duct (per meter): €6.50
Use of copper pipe cover duct (per meter): €12.00

Installation of heater switch:

In existing box: €20.00
In another location with external box: €35.00

Installation of external isolator according to the regulations of the Electricity Authority:

If armored cable is needed (per meter): €3.00
If a technician is needed for inspection by the Electricity Authority: €50.00
On-site technician presence: €50.00

Installation of plastic floor base for outdoor unit: €30.00
Installation of metal wall base for outdoor unit:

For air conditioners 9K to 14K BTU: €35.00
For air conditioners 16K to 24K BTU: €40.00

Use of lifting machine (per hour): €59.50

There may be additional charges for more difficult installations that cannot be calculated in advance.
Our company does not undertake drilling in concrete or stone walls, columns, or beams.
All prices above include VAT.

The term “installation” includes the following services:

Unpacking the unit.
Installing and connecting the air conditioner at a location specified by the customer or indicated based on the conditions of the space (according to necessary requirements).
Demonstration of use and explanation of basic functions and components.

Installation Requirements:

The maximum distance between the indoor and outdoor units is 3 meters, which includes the connecting cable of the air conditioner to the power supply and the water drainage pipes from the indoor unit.
All cables are covered with trunking; copper pipes are separately insulated with Armaflex and bundled together with white adhesive tape.
In all air conditioners, the power supply must be connected to a Heater Switch, unless the customer prefers a 13Amp plug only for air conditioners from 9K – 12K BTU.
The water drainage pipe from the indoor unit extends to the ground with drainage in Heating Mode, except for high-rise buildings, where the endpoint will be discussed and agreed with the customer on-site.
When holes are made in the wall for passing pipes, they are filled with suitable material.
“Vacuum” is absolutely necessary on the pipes after connecting the air conditioners.